How to size a power station
Four separate checks: energy, running output, startup surge and the correct power connection.
Start with energy, not watts
Watts describe an instant rate. Watt-hours describe stored energy. For each device, multiply its average active watts by its daily hours and cycling duty fraction. Add the device energies, then model power conversion, inverter overhead and a battery reserve.
Check what runs together
A 1,000 Wh battery is not necessarily able to run a 1,000 W load. Output wattage is a separate specification. Place device use on the clock and check the sum of overlapping AC loads. DC and USB ports have their own voltage and current limits.
Leave motor startup separate
Compressors and pumps can need a brief startup demand above running watts. Match that against a real documented surge limit. Do not substitute an advertised resistive-load boost feature for verified motor-start capability.
Test the exact setup
Use your appliance manual, label and a watt meter where possible. The estimated range is a planning aid; it cannot certify an installation or predict every real operating condition.
A worked example: one day of essentials
These are illustrative inputs, not measurements of a particular appliance. The fridge runs at 120 W for 25% of the day; the router is always on; the laptop runs for six hours.
| Device | Daily calculation | Energy |
|---|---|---|
| Fridge | 120 W × 24 h × 0.25 | 720 Wh |
| Router | 10 W × 24 h | 240 Wh |
| Laptop | 45 W × 6 h | 270 Wh |
That is 1,230 Wh per day at the appliances. At 85% AC efficiency, plus 8 W of inverter draw for 24 hours, the battery must supply about 1,639 Wh. With a 10% reserve and a full starting charge, about 1,821 Wh of nominal capacity is needed before the higher-consumption stress test. Startup and port limits still need separate checks.
Before choosing your setup
- Measure a representative day, including charging and compressor cycles.
- Enter operating watts, hours and quantity; use duty cycle only once.
- Choose your target duration and compare the conservative case without solar first.
Common questions
Should I enter the charger’s maximum wattage?
Use measured average operating draw if available. A charger rating can be a useful upper bound, but can overstate ordinary device consumption. Keep the maximum simultaneous output check separate.
Can a 1,000 Wh station cover a full day?
Only if the devices, losses and reserve fit within its usable energy and output limits. In the example above, battery-only operation would fall short. Simulate your own inputs instead of using capacity as a runtime promise.
This guide explains electrical planning for portable plug-in devices. Verify your exact manufacturer manuals and operating conditions.